Many thanks to SRAA contributor, Dan Greenall who shares the following recording and notes:
Reception location: Ancaster, Ontario, Canada
Receiver and antenna: Hallicrafters S-52 using a longwire antenna
Notes: Prior to July 1, 1971, time and standard frequency station WWV in Fort Collins, Colorado was giving ID's in Morse code as well as voice every 5 minutes. They were best heard here in southern Ontario, Canada on 10 and 15 MHz.
WWV Station sign at WWV in Fort Collins, Colorado
Many thanks to SRAA contributor, Myke Dodge Weiskopf, who shares the following recording and notes:
BROADCASTER: WWV
DATE OF RECORDING: December 08, 1991
STARTING TIME: 0218
FREQUENCY: 5000 kHz
RECEPTION LOCATION: Rockford, Illinois, USA
RECEIVER AND ANTENNA: Unidentified boombox
NOTES:
NIST Radio Station WWV as it sounded on 8 December 1991 at 0218 UTC.
Due to the high cost of maintaining the aging drum-based voice announcement machines, NIST implemented a digital voice announcement system in 1991. The new male voice, belonging to Eric Smith, started at WWV on 13 August. The voice of WWVH belonged to Johanna Stahl. The voices were sorely lacking in high EQ at first, but were sharpened with an audio filter on 27 August. The modification did not help, and after months of equipment failures and complaints about the poor quality, NIST retired both voices on 11 August 1992.
An excerpted version of this recording is found on "At the Tone: A Little History of NIST Radio Stations WWV & WWVH." This unedited version is being shared by special arrangement for the Shortwave Archive.
Many thanks to SRAA contributor, Dan Greenall, who shares the following recording and notes:
Broadcaster: Time signal station VNG Lyndhurst Victoria Australia
Date of recording: December 13, 1971
Frequency: 4.500 MHz
Recption location: Ancaster, Ontario, Canada
Receiver and antenna: Hallicrafters S-52 using a longwire antenna
Mode: AM
Notes: Recorded on December 13, 1971, here is the announcement given by station VNG in Lyndhurst, Victoria, Australia transmitting with 10 kw on 4.5 MHz shortwave. This station was active from 1964 to 1987. Receiving location was Ancaster, Ontario, Canada. Amazingly, the recording was made on a cheap Demonstration Musicassette that had tape placed over the ends so it could be reused. It still plays today and was used to produce this digital version. The announcement is given twice and goes: "This is an Australian Post Office standard frequency and time signal transmission from VNG, Lyndhurst, Victoria on 4.5, 7.5, or 12 Megahertz." This was given during the 15th, 30th, 45th and 60th minute of each hour according to their QSL card.
Many thanks to SRAA contributor, Dan Greenall, who shares the following recording and notes:
Time signal station WWVH in Kekaha, Kauai, Hawaii was occasionally heard over WWV in Fort Collins, Colorado from my receiving post in Ancaster, Ontario, Canada in the 1970's, particularly on 10 MHz or 15 MHz. Here is a recording of their voice announcement from 1971, when they were still using the term Greenwich Mean Time as opposed to Coordinated Universal Time. The familiar "Aloha" is heard at the conclusion of the announcement.
Reception location: Ancaster, Ontario, Canada
Receiver and antenna: Hallicrafters S-52 using a longwire antenna
Photo by Agê Barros
Many thanks to SRAA contributor, Dan Greenall, who shares the following recording and notes:
Prior to July 1, 1971, time and standard frequency station WWV in Fort Collins, Colorado was giving ID's in Morse code as well as voice every five minutes. They were best heard here in southern Ontario, Canada on 10 and 15 MHz.
Reception location: Ancaster, Ontario, Canada
Receiver and antenna: Hallicrafters S-52 using a longwire antenna
Many thanks to SRAA contributor, Dan Greenall, who shares the following recording and notes:
Early in 1973, WWV made this announcement that they would make regular broadcasts of planned ATM (Apollo Telescope Mount) schedules by the new Skylab space station.
Reception location: Ancaster, Ontario, Canada
Receiver and antenna: Hallicrafters S-52 using a longwire antenna
Many thanks to SRAA contributor, Dan Greenall, who shares the following recording and notes:
KC2XIO was an experimental radio station operated by the National Bureau of Standards in Boulder, Colorado between July 1970 and May 1971. This was to gather information in preparation of the format change for WWV and WWVH which happened in July 1971. Here are two recordings of their voice announcement (one male and one female) as heard in Ancaster, Ontario, Canada on a Hallicrafters S-52 receiver that was hooked up to an outdoor longwire antenna. The frequency used for these test transmissions was 13560 kHz shortwave.
Reception location: Ancaster, Ontario, Canada
Receiver and antenna: Hallicrafters S-52 using a longwire antenna
Many thanks to SRAA contributor, Paul Walker, who shares the following recording of BOM and notes:
BPM on 10 MHz surpassing WWVH’s signal, which does not happen often at all—if ever that I can remember—in McGrath, Alaska.
The dits form BPM are obvious, but the morse code beginning at 39 seconds and the voice at 1 min 21 secs just wipe away WWVH.
Many thanks to SRAA contributor, Bruce Atchison, for sharing the following recording and notes:
This first [recording in a series I’m sharing] is of CHU Canada. I recorded it in July of 1993 on 7,335 kHz with my Kenwood TS-690S transceiver:
Many thanks to SRAA contributor, Myke Dodge Weiskopf, who shares the following recording and notes:
NIST Radio Station WWVH as it sounded in the 1980s. To contrast with other recordings of the WWVH station ID, note that announcer Jane Barbe does not say (her now-famous) “Aloha!” at the end of this version.
This recording was found at WWVH in 2015 on an undated cassette labeled “JB on Old Audichron TCG” (which stands for Time Code Generator, the device which reconstructs and plays back Jane’s voice over the air). As such, the precise broadcast year is not known, but it is consistent with the voice and broadcast format of the 1980s, until the introduction of the short-lived digital voice in 1991.
An excerpted version of this recording is found on "At the Tone: A Little History of NIST Radio Stations WWV & WWVH." This unedited version is being shared by special arrangement for the Shortwave Archive.
Many thanks to SRAA contributor, Emilio Ruiz, who shares the following recording of WWV and notes:
Sad for the news, the closing of WWV is like close a park, a comunity place where scientifics and enthusiast of radio could learn and experiment not only about time, radio propagation too. I not have much money for bought radiofrecuency equipment for repair or make my own radios, i use WWV for that.
To go to the future it is not necessary to destroy the past, I'm teaching to children about science and technology and when talk about radio share with they the listen of WWV with old radio receiver (BC-548Q), for they the sound of ticks and the history about radio and time is a amazing topic.
I wrote this review (in Spanish) about WWV for those SWListeners and Radio Amateurs who do not spoke English,--I think can be useful.
I hope radioamateurs of U.S. can reverse the decision.
Broadcaster: WWV
Date of recording: 11/3/2017
Starting time: 14:00
Frequency: 15000 kHz
Reception location: Chiapas, México.
Receiver and antenna: Dipole antenna, Keenwood R-600
CHU Canada Time Signal station at 1005 UTC. Broadcast at 10 kw from Ottawa. Received in Sydney, Australia, using a Degen DE1103 and a 40 meter longwire.
The Shortwave Radio Audio Archive (SRAA) is a collection of shortwave radio recordings that you can download or listen to as a podcast. The collection grows every day and includes both historic recordings and current recordings from the shortwave radio spectrum.
The goal of this site is for shortwave radio enthusiast to have a place to store, archive and share their radio recordings with the world.
Click here to learn how to contribute and archive recordings.
Subscribe to the archive on iTunes,
You can subscribe to the archive with any podcasting application by subscribing to our RSS feed. Simply right click and copy this RSS feed url, then paste it into your podcasting application's subscribe box.
